7 Wonders Box Organizer/Insert - All Expansions

I needed an organizer so that I could put the base game and the Babel expansion in one box. I found the one I remixed that was designed for all expansions. I noted several comments that said that it didn't quite fit their box - slightly too large. When I measured, I found that it was about 3 mm too long in one direction - the direction of the long player board and Armada trays. We'll call that the y-axis.

So, by making thiner walls in several of the trays, I was able to cut 3-5 mm off of the trays in the y-axis and now it fits my box. I also had to cut the 2 long trays into 2 parts to be able to print them on my Creality K1. They were too big for my build plate.

Here are the changes I made from the original
-Player board and Armada trays are 3-5 mm shorter
-Player board and Armada trays have a 2-part version to be able to print on a smaller print bed
-Armada token tray, 7 Wonders token tray, Babel token tray, and Bable tiles tray are all 3-5 mm shorter
-Coin trays are 4 separate trays with lids

You'll need to print 4 card trays and lids.

I don't have all of the expansions, so I can't confirm that everything fits in them like it should. I don't think I changed anything that would make a component not fit, but it's possible.

The card tray still needs improvement. There is only one section that is big enough to fit all of the cards from a single age without really forcing the cards in.

Printer Brand:

Creality

Printer:

K1

**Rafts:**

No

Supports:

No

**Resolution:**

0.2

Infill:

15-25%

**Filament:** Anycubic PLA and Amolen silk PLA PLA
Mostly black with gold trim

Notes:

Armada Tray
If you're printing the 2-part Armada tray, I recommend printing it with the connectors up, which is a little weird. But the connectors and holes for the connectors come out way better than if you print the trays flat and use support for the connectors and holes.

Coin Trays
The coin tray and lid .stls have a solid bottom and top. I got the grids you see in the pictures by printing them with 0 top and bottom layers. I set the infill to hexagons and 25%.

How I Designed This
===================

I used Deck in a Box to design the coin trays and lids: https://deckinabox.sgenoud.com

I used TinkerCAD to cut down and split the trays

Category: Games