Robinson Crusoe Collector's Edition Game Organizer

Hello Robinson Crusoe Collector Edition backers or purchasers. Many of us have struggled with the game organizer that came with the collectors edition, namely we have a collectors edition box that only can contain the base game and not the expansions, or even all the minis... and don't get me started on the Book of Adventures.

For this organizer my goal was to get the base game (minus the game board as I have the mat), the Stretch Goals, the Loury Totems cards, the Pirate's Map cards, the Rotten Wounds cards, the Horror Dice, the Resin tokens, the Sailor and Gamer pack, the Book of Adventures, and the Mystery Tales expansion all in one box. I don't have the Treasure Chest expansion so I could not be sure how to accommodate it.

Features:

- Card holders and dividers that fit all the large cards I had as well as a smaller card holder to accommodate the smaller cards. - Indentions for Mystery Tales tiles and the character boards (including the Sailor and Gamer) - Notched cutouts and relief to support the book of adventures (including it's original wrap)

To print the whole thing you will need to print the following:

• 2X - RC_Card_Holder

• 2X - RC_Inside_Middle

• 1X - RC_Inside_Top

• 1X - RC_Inside_Bottom

• 1X - RC_Outside_Top

• 1X - RC_Outside_Middle

• 1X - RC_Outside_Bottom

• Any number of Dividers you want or need for the cards.

• RC_Lg_Token and RC_Small_Token holders are optional inserts that fit into the two RC_Inside_Middle trays to better organize the tokens

Pictures included show how it all goes together. If there are minor suggestions I may be able to make tweaks. I am also going to try to engineer a v2 so I can store the game board as well.

I hope it is helpful... we sure as heck deserve something a bit more thought out then what was given.

EDIT I have created two optional token holders for the two inner trays to better help hold tokens in place. Now there is even more room.

• Printer brand: Bambulabs

• Printer: Bambu P1S

• Rafts: No

• Supports: No

• Resolution: .2 Layer Height

• Infill: 30%

• Filament brand: Hatchbox

• Filament color: mixed

• Filament material: PLA+

• Notes: Should not be a need for rafts, skirts, or supports unless dictated by your filament material.