Tainted Grail Kings of Ruins insert / organizer

If you want, you can help me with designing inserts by donating here:

Hello,

for those that don't know my ‘insert philosophy’ - I am creating modular inserts that are focused on reducing setup and space on table, filament consumption is not my highest priority, but of course I'm trying to save some material where I can.

• If you want to acquire commercial licence for this model, visit my club page on printables,

• my inserts are without lid lift unless I specifcally state otherwise,

• Clearence for holder covers is very small - 0.2mm horizontal. Please print the smallest holder and cover for it to check if it fits, if not you may need to calibrate printer or enlarge cover a bit (adding 0.2-0.4mm to the width in the slicer should be enough).

• vertical storage ,

• black goat of the moors,

• modular campsite,

• stretch goals ,

• sleeves - 70 microns

• character dashboard - it acts as a dashboard during the game and as a save system for your character. Everything except character location and miniature on the map can be saved in this dashboard:
• 2 shelves for abilities, 12 ability covers - if cover is on the ability - it's not yet unlocked, if it's under - it's unlocked, you can even save them with slotted cubes, shelves slide in with them without any issues,

• 2 slots for cards with 2 separators each - for saving your deck and storing not yet unlocked cards,

• resources shield - for safely saving the resources and equipment cards,

• health tracker extension - just to make sure that it won't come out when it's stored inside the box,

• cover - to slide cover you need to keep the right shelf open, you don't need to take it out of the dashboard though,

• cards holder - main card holder for most of the cards,

• cards items holders - one holder for each item deck,

• cards random encounter, chapters, small secret, one time items, camp holder ,

• resources, tokens, monsters, other holder,

• minis characters holder - for almost all character miniatures, except one for one of the characters which is noticeably larger,

• minis holder - for all other miniatures + larger character miniature.

• about 2085g filament needed, (depends on your settings, I printed with 12% gyroid infill, 2 walls, 4 top and 3 bottom layers, 0.42 line width),

• at least 249mm x 193mm print bed.

Supports - no supports required.

• every file ended with xX (for example x16) - print X times (in given example - 16 times),

• refer to pictures how to organize the box.

• I don't quite like the 2nd layer of the insert, to be specific 2nd card holder, item card holders, character miniatures. Maybe I will redesign them a bit. I would love to have all cards, except item cards, in one holder, but I ran out of ideas how to squeeze them in. Maybe I will revisit it in the future.

Enjoy!