← Res Arcana ← lionpants

MakerWorld · added Mar 11, 2025 · updated Jul 22, 2026

199 downloads · 49 likes · 23 comments

LayerUp history

Added to LayerUp Jul 11, 2026

added by Scout

listing refreshed Jul 22, 2026

5 views

Table Talk

Nothing here yet. Love this design? Say so - the designer might see it.

Res Arcana Insert - Expansion 1, 2, 3 (Duo)

for Res Arcana (2019)

lionpants + Follow

Inserts

5 plates 11h 1m 0.4 mm 544 g PLA Free

View Print on MakerWorld

Please support lionpants by Liking/Boosting their Print on MakerWorld.

Before you print

✓ Needs about 544 g

✓ Stores vertically

Print profiles

0.2mm layer, 2 walls, 15% infill

5 plates 11h 1m 0.4 mm 544 g PLA

Partially merged - less moving parts

3 plates 10h 30m 0.4 mm 559 g PLA

As sliced by the designer. Your printer, filament, and settings will change these numbers.

An insert for the fantastic board game; Res Arcana. Supports all currently released expansions.

I adjusted Nemyh 's fantastic insert from Cults3D as well as ludalito 's essence tray from Thingiverse to work together. Support for the new Res Arcana Duo expansion was also added.

Supported Features

✔️ Sleeved Cards (should fit all brands)

✔️ Vertical Storage (Essences stay in the tray without using a lid when the box is flipped upside down)

✔️ Expansion 1

✔️ Expansion 2

✔️ Expansion 3 (AKA Res Arcana Duo)

Notes

⚠️ If you decide to glue all 4 parts together, I recommend only gluing parts A+D together and A+C together, then both halves can move freely in the box. This is because some of my Places of Power were actually varying sizes which caused a tight fit if all 4 parts were glued snug together. Your mileage may vary.

boardgame accessories boardgameinsert boardgameinlay boardgameorganizer