Dixit Odyssey voting peg

I lost a few of my voting pegs for Dixit Odyssey and that was main excuse for purchasing my first 3D printer and explaining the purchase to my wife. 😅
Boost Me New to 3D world of printing and modeling , first printer, first model. This model is the reason I purchased my printer :) Thanks for any boosts!

Peg height in total: about 15,5mm

Cap diameter: about 9,2mm

Leg diameter under the cap: about 4,4mm

Leg diameter at the bottom: about 4,1mm

Model contains 4 versions, depending on your preferences and wear of your paper voting cards

• Standing 100% with suppport.stl

• Upside down.stl

• Standing 102% with suppport.stl

• Upside 102% down.stl

Standing versions with support give best results and uses the most filament (still - trace amounts for such small print, worth it)

Upside down versions do not use support, but the quality of the cap is far from satisfactory, even with 0,12mm layer height.

Print scaled to 102% is your paper voting cards were frequenty used. 100% should be ok for brand new cards - but if that's the case, you probably shouldn't have any pegs lost in the first place😅

Tried with Bambu PLA Basic and Sunlu Silk PLA+ DualColor