Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.
Log in to join the conversation.
The Godfather movie poster fridge magnet
1 plate
3h 46m
0.4 mm
53 g PLA Free
View Print on MakerWorld
Please support crabstiks by Liking/Boosting their Print on MakerWorld.
Before you print
✓ Needs about 53 g
The Godfather movie poster fridge magnet
4 colour AMS print, using black, white, ash grey and red.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
