Steampunk Rubber Duckie: High Society

Steampunk Rubber Duckie: High Society

Elegance meets eccentricity in this high-society duckie, dressed for a gala in the gear-laced halls of Victorian futurism. With a brass-buttoned vest, gear-studded corset, and a top hat that whispers mystery, this duck is ready to waddle into any elite airship soirée.

🧵 Print Notes

• Layer Height: 0.12 mm for crisp gear edges, corset seams, and goggle rims.

• Offset Start: Begin print slightly above the plate to ensure the corset’s bottom edge lays clean — this avoids distortion and preserves the silhouette.

• Supports: Optional — under hat brim and corset flare if needed.

• Infill: 15–20% for balance and weight.

• Material: PLA or silk PLA for shine; AMS users can assign brown, brass, and yellow zones for full steampunk drama.

• Adhesion: Brim recommended when printing offset.

• Speed: 45 mm/s for outer walls to preserve stitch lines and gear contours.

• Cooling: Active, especially around the corset folds and goggle rims.

🛠️ Remix Tips

The vest and corset zones are cleanly separated for easy kitbashing. Add a monocle, cane, or feathered bustle to elevate the aristocratic flair. The flat corset base is remix-friendly for alternate textures or trim.

She is hard to print! It took me about 10 times to get one where the Corset would print correctly. If you find a better profile please add it. I really like how she came out. But it isn't the easist model to print.

Boost Me If you like this give me a boost thanks for the consideration!