Log in to join the conversation.
Railroad ink insert (base set, 3 expansions)
Please support Tynam by Liking/Boosting their Print on MakerWorld.
I only own a few sets for Railroad Ink, and I wanted a simple insert that could hold a base set and a few expansions, with all the pens and boards, without hassle. Something to make it easy to take a single box to game night.
Horn93's insert ( https://www.thingiverse.com/thing:5996375 ) was very close, but I wanted a few tweaks, so I've remade it. The height is a tiny fraction lower so there's no lid lift, and I've tweaked the finger spaces to make dice easier to remove. I've removed some areas to save filament.
No supports or raft needed. Low infill is fine; I used 10% cubic.
A small brim is recommended to prevent shrinkage at the corners - don't remove the brim when printed; if you leave it on the brim will fold up and 'lock' the insert into the box, preventing it from sliding about or coming loose.
Works with 0.4, 0.6 and 0.8mm nozzles.
