PokéStop-Inspired Penny Sleeve & Top Loader Holder

for Tabletop Accessories

Vog93_3D + Follow

Organizers

Free

View Print on MakerWorld

Please support Vog93_3D by Liking/Boosting their Print on MakerWorld.

Check out New Version 2 !!

Check out this Pokemon Fidget Spinner for a quick print!!

Thanks to everyone who printed the model, the positive and consrtuctive feedback. I made some updates and released a V2! If you liked this model or want a slightly improved one and found yourself here check it out!!!

https://makerworld.com/en/models/2425755-pokemon-top-loader-holder-v2-print-in-place#profileId-2660615

Update 3/14/26 - Enabled A1 Mini as a default printer selection…I had no idea it was not enabled!

Boost Me A boost if you like it is apreciated!

UPDATE 7/27/25 - Changed print profile, previous was used for testing purposes (lightning infill). Replaced with stronger version of the holder base. Posting secondary model for quick printing.

I designed this penny sleeve and top loader holder to keep my card protection supplies neat, accessible, and a little more fun. It's styled after a PokéStop, with a red sloped roof, black trim, and a Pokéball emblem on the front that gives it a Pokémon-themed look without being over the top.

The left compartment holds top loaders, which can be pulled out one at a time from the bottom. A small finger slot and slope at the base helps push the bottom one forward just enough to grab it cleanly.

The right side holds penny sleeves, which are easy to slide off the top whenever you need one.

When it’s time to reload, just lift off the lid — it’s quick and simple.

Whether you’re building decks, protecting pulls, or organizing your collection, this holder adds personality and practicality to your setup.

Designed to fit even on the A1-mini. Can print without the Pokéball or even the lid if you want a less Pokemon themed holder!

Pokemon Pokemon TCG Pokeball pokemon poke pokestop TCG mtg yugioh card