Crystal Cribbage Board

I wanted to produce some unique gifts and came up with this print. It did require a fair amount of post processing. This was printed on an Ender 3 V.2 Neo (modified with a heated enclosure). Because I wanted a highly polished look it was printed from transparent Polycarbonate. It was printed with three bottom layers and six top layers since a lol of sanding is required to remove all the layer lines. It then was polished using an automobile polish and an orbital buffer.

I used two perimeters and 15% grid infill, you can chose whatever you want for this. It's possible you could print this from ABS/ASA and use acetone smoothing, but I haven't tried that and don't know how it would turn out. It would save a lot of time sanding though. The pegs were printed standing on their heads with a brim.