Zombicide Green Horde and Expansions Retail Sleeved Insert Remix

I just made some simple tweaks in Tinkercad to open up the spaces for the cards so that they could handle 60micron sleeves (Sleeve Kings Mini American). It's not quite as clean of a look but I mostly made this to be functional.

I also did some small edits on some of the really oversized boxes that only hold a few things so that they could be printed upside down with zero infill and only bottom layers so that they print more or less like a regular store bought insert would look. This saves a lot of filament.

I added little risers to place underneath the token holders that sit around the maps. I did this because I preferred the insert by tanne7 over on Thingiverse. It's in the remix models listed here. You will need 3 short ones and one long one. This brings these token holder up to meet flush with the maps after adding the expansion maps in. Again, these save on filament.

Lastly, I changed the words in the boxes so that they create full holes that go all the way through so that you can print with no top/bottom layers and use an infill pattern that you like to create one of those perforated looks that again use a lot less filament.

Fair warning, there is a tiny bit of unavoidable lid lift but it is negligible.