Loopin Louie - Extension arm inner holder

0.20mm Standard
ABS
Wall loops: 4
bottom shell layers: 4
Sparse infill: 35%
Infill/Wall overlap: 20%

Designed for wood screws: 4mm x 20-25 mm with flat head max 7 mm x 3mm. Predrill hole for fastening with 2/2.5/3 mm depending on used screw internal diameter (before thread). Screw head will lay flat with upper surface. Do not drill any holes to extension arms.

Recommended: longer crews and shorten them to increase strength or use screw without sharp tip. Wood screw sharp tip without thread is not holding.

Print 1 for each player (4 or 8).

At the extension arms there is higher part at the right side from the presser. This item is designed to be installed inside of the extension arm at the bottom of the higher part next to presser. Install one at time to get locations correctly.

It is designed to fit perfectly to prevent board from moving sideways and designed to be used with Loopin Louie - Extension arm outer holder and Loopin Louie - Extension arm coinbase holder .

If you'd like to support me.. you can go to