Golem Boardgame marble dispenser reinforced

I don't own this game, but I was asked to print this, and immediately was suspicious of the strength of the pegs once people started hurling marbles at them... I could easily see pegs shearing off at the back surface. So I decided to make a slightly stronger version, with indents on the front plate and holes through the back so the pegs rested on ledges - however small, they're better than nothing.

Print the back & front, glue together, then print the pegs - make them as long as you like - insert through the holes with a blob of glue on the end (it's tricky, practice before applying the glue) and press firmly into place into the indents on the front plate. Once the glue dries, trim off the pegs at the back and apply some glue there too.

The pegs at the back are visible (I tried to take a pic, but the camera didn't pick it up too well), so if you don't like that, this isn't for you.

The base isn't changed from the original, but I include it for completeness. I used 3d Builder to make the modifications.