Saboteur Board Game Box

I've been printing my example on 0.4 nozzle, but the lines on the images are quite small, so need to make 0.2 line width. Off course, it's not the best scenario and maybe later i'll do another print with 0.2 nozzle. Printer with that configuration in .3mf struggled to make clean walls, so be careful. It's better to use 0.2 nozzle or/and lower the speed. I printed first layer 25/50 and it looked ok. Next layers i printed with outer wall 200 (.3mf should have configured 100, but i don't know the result) General config i used: 0.08 Extra Fine Layer height 0.08, Initial layer height 0.08, Line width - Initial layer 0.2 - Outer wall 0.2 - Inner wall 0.2 Wall loops 2 Sparse infill density 100% (without this walls may be too weak) Initial layer speed 25 Initial layer infill speed 50 Outer wall 100 (I was using 200, not super happy, but not sure about 100 either) No brim No prime tower Second plate was printed with standard 0.12 Fine