Saboteur 2 Game Box Organizer

Saboteur 2 is an awesome game, but the plastic organizer it comes with only has 3 slots for cards, has no slots for gold tokens, doesn't fit sleeved cards, and is very space inefficient.

My divider has 5 slots for cards and 2 for gold pieces (I recommend 3 for the deck and 2 for other cards, possibly 1 for gold and 1 for dwarf and other cards).

I printed mine in ABS but it's probably fine in PLA (but let me know in comments if you try)

The cards are 56x87mm, and the current insert is 57x89, but sleeved cards are 58x89 and don't fit inside the insert. I needed a few mm inside the hole for the cards, a few mm for the wall between them, and a few mm on the walls of the insert. The current insert is 151 by 211mm, and my organizer is 1mm smaller on all sides because the original was such a tight fit. My divider being 150mm wide was rough because 58+89 is 4 off of 151, so I went without walls on the sides and added just 1mm of room for cards and a 1mm wall between cards, since the spacing is super tight in that direction.

The entire design is 150x210 and the card slots are 59x90 with 1mm walls. The height is 25 and the base height is 3. All units are mm.

It fits everything perfectly, partially thanks to the cards being able to go past the divider and touch the box.

If I was to complain or suggest improvement, it would be that the cards are hard to pick up (when sleeved) and that the insert could be a little wider (151x211 rather than 150x210mm). Also, 3mm for the base thickness is a bit overkill, but 1mm for the walls is too tight.

Another suggestion for improvement would be to allow for holding more types of cards with dividers and slant the cards. The box isn't tall enough for the cards to lay on their side, but if slanted at a steep angle it would probably fit.

Let me know if you enjoy or have any suggestions. This is my first design (not a remix) that I've created and uploaded and my second design I've created. Thanks!