Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.

Dragons Down Game Organizer

10 plates 81h 57m 0.4 mm 1,541 g PLA Free
View Print on MakerWorld

Please support moofrank by Liking/Boosting their Print on MakerWorld.

Before you print
Needs about 1,541 g
Covers Dragons Down: Desolation

This is an insert for the Boardgame Dragons Down (which is a lovely riff on the classic AH Magic Realm).

This will hold the Legendary edition with metal coins, and the Desolation expansion in a single very heavy box with about 20mm lid lift.

This insert uses 6 of the existing chip trays: 5 have the terrain-specific monsters, and one has the heroes. A half-tray is provided to fit in the two shared monster groups (Orcs & Dragons). The photos below show the layout in stages.

Use notes and imperfections.
Terrain trays stack in 4's, each holding the cards and tokens plus hex tiles for each terrain. There is also a small inset below the lid for the setup board. The 5th smaller mini tray is too small for the setup board, so I sadly pile it in with one of the other setup trays. Cards for that mini-terrain tray are below the hex tiles. You COULD print lids for these extra terrain trays, but with the setup boards and stacking…don't bother.

Targeting tokens and wanted tokens go into the unmarked bottom Legend and Fame point tray.

The Heroes and poker-size card box is a bit tight, but there is some squish you get from the vacuform chip trays to make room.

organizer insert boardgame

Full Organizer Posted: