New York Slice Board Game Insert

Insert for the board game New York Slice. Keeps the slices in a more thematic pizza shape in the box, rather than a big mess or other stacking methods. There are holders for the cards as well.

Print four of the corners plus four of the spacers. If you have a larger print bed, print four of the joined parts instead. Holes are in the back of the corners to save filament since it does not act as a container, only the surface facing the inside is structural

Print two specials card holders.

Corners go in the corners, spacers in between. They should all fit with only a little wiggle room to spare. Card holders loosely clip onto the corner pieces so they don't slide too much in the box.

If you have trouble getting the slices out, remove a piece of the insert and then put it back after. I was going to attempt to put a divot in one of the pieces to make it easier, but removing a piece is just as easy.

The card holders ended up a little higher than intended. They raise the lid a tad, but toward the front it's not a large factor.

**EDIT 2018-03-25**: I added a v2 of the corners and specials holder so they should notch into each other, but I have not yet personally tried it. With the reduced size of the v2 specials holder, you will need to print 3 of them if you choose to use them.

**EDIT 2019-04-22**: Removed files including the New York Slice logo by request of Bezier Games

**EDIT 2019-04-28**: Had to upload as a new thing since the old one was removed due to the logo and it won't be restored.