Scythe RifRaf 3d Factory Tile

This is the Scythe Factory Tile I made in collaboration with Derek from BGG, I compiled it from a number of other sources including Thingiverse… so thanks for your contributions Thingiverse people... I saw Justin posted a 3D tile and figured you would want this one to see about as well... Good Job Justin
Yes it was a big challenge but YES it prints... At a fine level it took 46 hours to print. I used only 8% supports at a 80 degree acceptance... otherwise you get supports everywhere that would be too difficult to remove.
Check out some of my other posting for the full set of Scythe 3D Pieces.
My Scythe Pieces:
https://www.thingiverse.com/thing:3154939