Slay The Spire - Board Game Insert (Retail Edition)

Hi everyone, i created Insert for Slay The Spire - Board Game Insert (Retail Edition), because i could not find one that i would like.

All Player Cards and Acts are separated - you just take them out, put on the table and use them as card holders, you can see the card holder on the pictures. This saves time and the table is organized.

I was able to fit essential components for the game, that are not included in Retail Edition:

Insert

Player Card holders (for active cards) (4x)

Small Player Tray (for money) (4x)

Monster Health Tracker (16x)

Key holder

------------------

Print:

Slay the Spire - Player Cards - 4x

Slay the Spire - Player Miniature Tray LID - 4x

Slay the Spire - Player Miniature Tray - 4x

Slay the Spire - Act 2 & 3 - 2x

Slay the Spire - Player Card Holder - 4x

Slay the Spire - Life counter - 16x

Slay the Spire - Ascension, Unlock - Divider

Slay the Spire - Player Miniature Tray LID

Slay the Spire - Player Miniature Tray

------------------

Tips:

-No supports needed for printing

-These models has to be rearranged on the plate, to print them properly:

------------------

I Am using thin sleaves (65*90mm)

I have used: The-Boardgame-Insert-Toolkit

I have used: Fusions360 for personal use

------------------

My print setup in Prusa Slicer
Nozzle - 6mm

Layers and perimeters:
Solid Layers - Top = 0; Bottom = 0
Perimeters - 3
Seam position - Aligned
Perimeter generator - Arachne

Infill
Fill density - 40% or 30%
Fill pattern - Cubic