Token Storage for Shadows of Brimstone

This is a chit / token holder specifically for Shadows of Brimstone, however it will work in any game with a large number of 30mm and 21mm circular tokens such as most FantasyFlights or Flying Frog games.
One of the trays is meant to hold a combination of the 30mm and 21mm tokens, the other just 21mm tokens. Printed together they are sized to hold the full stack of each type of token from one of the base starter sets from SoB.
If you would like to use the trays as storage in addition to in-game dispensing then print out enough of the caps to use. They stay in place by friction and so a relatively coarse print setting lets the slight striation from the FPM print lock the caps in place.
This was my very first tinkercad design and among my first 3d prints so it is extremely inefficient. There's lots of wasted plastic and some of the base decorations cause the print to take longer to complete than strictly necessary. However I'm still proud of this like a small child of their macaroni picture.