Xia Legends of a Drift System (plus expansion) coin holder

A coin holder for Xia: Legends of a Drift System board game, including the Kickstarter coins and Embers expansion.

The Kickstarter coins are 2,000Cr and are orange. They're still available other places including Amazon or eBay should you want them.

This is completely unaffiliated and not approved, endorsed, etc. by Far Off Games or the designer.

---------------------

In my game play, I had typically divided the coins across the table in cups/jars/plastic condiment containers, etc. I then had to drop them back into the bag (for Embers' 10x 1,000 Cr coins and the Kickstarter 2,000 Cr coins) or replace them in the inner box liner/organizer (which wasn't sized for the expansion or the 2,000Cr coins).

I designed this to divide the coinage in half for each side of the table, such that they could also be used to store the coins in the box.

You need to print a lid, and two of the holders as each one is designed to hold half the coinage from the base set plus the expansion, plus the 2,000 Cr coins.

There are two versions of the holder, one for if you have, in total:
-- 40x1,000 Cr, 10x2,000Cr, and 10x5,000Cr coin sets
(version name: XiaCoinHolder-20x1k-5x2k-5x5k)

-- 40x1,000 Cr, 20x2,000Cr, and 10x5,000Cr coin sets
(version name: XiaCoinHolder-20x1k-10x2k-5x5k).

From the naming, it's per holder (so you print two), and is divided by how many 1,000 Cr, 2,000 Cr, and 5,000 Cr each version can hold ("10x" holds 10 of that type).

The version pictured is the previous version, whose only difference is that I changed the coinage markings to be larger and easier to see without using a pen to make the lettering show up, as is in the picture(s).

This is fine for FDM printing as pictured, however, size all the parts up in the x & y direction by about 102% in your slicer. That's because in my print, I found that the bottom of the containers was a bit too small for some reason and the coins wouldn't lay flat. Sizing it a bit wider in x/y should fix that. (just make sure you do the same for the lid).