Marco Polo II insert

Just to be clear this is NOT a revised insert for Marco Polo, This is an Insert for the sequel "Marco Polo II: In the Service of Khan". The insert for marco polo was the first one I did and really got me into 3d modeling, It also has a lot of warts as I've learned a lot since then. So this one is a good bit sleeker ;) Also Keep the insert that came with the box so that everything is snug and does move around too much. Unfortunately the even the small cards are a little over 46mm with the bottom on insert and 2mm clearance at the top the overall insert is 48mm tall, the amount available in the box after the board and other parts is 46mm. so the box doesn't completely close any longer. by about 2-4mm.

For a change I'm not looking to make something that holds everything. The goal is to speed setup and tear down. As I have it designed the destination cards, start marker and the black dice are not in anything I'm printing but I there is a spot to keep them in a bag in the box. The full size cards also contribute the box not closing.

Category: Toy & Game Accessories