Dominion card carousel (small printer friendly)

This remix is printable on a much smaller bed compared to the original source. It uses an empty filament spindle to provide the base and two tiers. If you want it to rotate like the original, print a spindle holder .

Print 8 card_holders and (optionally) one center bowl for holding chits.

See post-print steps for assembly directions.

Place an empty filament spindle flat on a table with 3 card holders on top in a triangle. This is the top tier. Trace around them with a pencil.

Cut along the pencil line to remove the unneeded top tier spindle material. I used a power jigsaw, but any saw or cutting tool could work.

Glue all card holders in place. 5 on the bottom tier and 3 on the top tier.
I found it easiest to glue the bottom holders to each other first, then glue them to the spindle.

(Optional) Print and glue the bowl in the center of the top tier.

(Optional) Print a rotating base