← Arkham Horror ← Astuni

Printables · added Dec 7, 2019

248 downloads · 24 likes · 1,963 views

LayerUp history

Added to LayerUp Jul 11, 2026

added by Scout

listing refreshed Jul 18, 2026

Table Talk

Nothing here yet. Love this design? Say so - the designer might see it.

Arkham Horror LCG Chaos Bag Token Chip

for Arkham Horror (2005)

Astuni + Follow

Tokens & Resources

Free

View Print on Printables

Please support Astuni by Liking/Boosting their Print on Printables.

Been searching for solutions to pimp up my chaos bag for a while, and i'm not a fan of the coin capsules everyone else is using, so after stumbling upon something similiar over etsy i thought about modeling my own version.

This is a token chip for chaos tokens, fits the stock cardboard tokens precisely and the two halves are joined via snap fit pegs on a very tight and effective solution with no glue needed, also they can be easily opened if you need to take the tokes out of them.

Make sure to print these in pla as petg is not that good in printing such small things (pegs are very tiny), print two halves for each token (88 pieces for 44 tokens total).

My settings for pla were 2 perimeters and .20 layer height. Make sure your extruder is well calibrated as the fitting is very tight and you may end up flush or too tight depending on how much you're under/over extruding.

Enjoy!

Print instructions

Print in PLA, 0.20 layer height, 2 perimeters.

boardgames token arkham ahlgc