Log in to join the conversation.
Dog Lover (board game) Stackabowls
Please support Ben V by Liking/Boosting their Print on Printables.
These are print-in-place, no-support-required bowls to hold components for the AEG Game Dog Lover. These should hold cubes from the game and stack to stay within the original box without modification.
This is NOT licensed, endorsed, or approved by AEG or David Short, but a print of these were made at his request and delivered to him. He said he was fine with the sharing of the files as long as I wasn't charging for them.
They are sized to be similar to the dog that comes with the game and they are roughly 55mm on the large side (for most dogs - small dogs are, well, smaller). All are 9mm thick, similar to the original piece. Please let me know if there are missing dogs and I can see if I can't find additional breeds to add to the listing. There are close to 40 so far, so there are a bunch of pictures below. Additionally, there are some game-sized dog bowls you can print to keep your pieces in on the table. They are sized to stack and fit in the box and have the food type embossed on the sides while printing. Dog Lover Dog Bowls
