Bulldog for Battletech

This model is based off of the CGL sculpt. It is designed only for 0.2 nozzle.

PARTS:

This model comes in 6 main parts, plus 2 extra turrets to change the “pose” of the turret (a.k.a. the barrel is at a different angle) AND a hex base.

Print Recommendations:

I recommend printing only the parts needed to make one complete tank in one print, and printing the hex base separately for improved quality.

This model shares the same turret size as my SRM Carrier and my LRM Carrier . This means you can switch turrets and hulls around between these 3 models!

Assembly:

Note: you don't need glue for most of the tank assembly (it does kind of snap fit), but it is HIGHLY recommended to do so.

Turrets are interchangeable with SRM CARRIER & LRM CARRIER.

1: Glue treads to main hull of vehicle. (Tip: If the treads are not flush with the main hull, you got em backwards).

2: Take the block and make sure the bottom of it (side touching the build plate) is pointing down (towards where the road would be). Slide it into the back slot of the main turret part with some glue, DONT PUSH IT ALL THE WAY IN YET.

3: Put glue on the rear turret cap and push against the block until both turret parts are flush with eachother. Make sure the more detailed side (of the rear turret piece) is pointing up.

4: Glue turret to main hull in desired position.

Boost Me Did you enjoy this vehicle? Consider boosting!

Want more vehicles? Check out this collection!

Support Vehicles