Blood on the Clocktower - Boxes - (Life Tokens and Misc. Pieces)

Note: This is a remix of a design by “serenitynow” that I found on MakerWorld. The original can be found here: https://makerworld.com/en/models/768934-blood-on-the-clocktower-inlay-retail-version

Description

Due to my specific setup with storing things in the grimoire, I only wanted a few parts of the larger tray and wanted the lids to be the full height of the box. The changes worked out pretty well, and I’m satisfied with these boxes so I figured I’d share the remix as an additional option for those looking to further organize their game. It was also nice that I could fit these smaller boxes on my print bed without splitting the models.

The main limitation of this design is the life tokens box will only store 17 of the life tokens. This leaves 3 to store elsewhere, however I don’t typically use travellers so that’s not a big deal for me. As a result, I didn’t care to change this from the original design.

Also, I typically just toss my grim clips into the misc pieces box since those come out first to build the grim. Its not an issue for them to be mixed in with the reminder tokens or the death shrouds for storage.

Clearance

Both lids - 0.375 mm per side for a total of 0.75 mm in each direction

My printer’s tolerance isn’t very tight so these clearances may be larger than what you prefer. I used a clearance of 0.375mm per side. This allows the lid to slide on and off really easily with just small amount of friction.

I’ll include a couple stl files with a smaller clearance (0.25 mm per side), however I can’t guarantee those will fit or work because I did not print them myself. Those files will be labeled with “NOT_TESTED” to make it obvious.

My Print Details

Printer: Ender3 (Old and frustrating, but it works… sometimes)

Plastic: PLA

Nozzle Size: 0.4 mm

Layer Height: 0.2 mm

Infill: Cubic - 20%