Rolling Tray and Dice Holder: 6x3mm magnet REMIX

Overall dimensions at 180 x 120 x 30mm. Magnets used are 6mm diameter x 3mm height. The inside rolling area is ~112mm x 118mm.

Designed for a press-fit of magnets, so it might be tight. Make sure you have a well-tuned printer and try the test piece first. Sometimes it comes out slightly loose, I've had one out of 40 tests be loose, if this happens just use super glue. Make sure to use very little glue because glue squeezing out will make the fit less flush.

You may want to add some sort of felt to the bottom, but it totally works fine without it. It mostly comes down to the sound you want when rolling.

Sean Rogers made the original: https://www.prusaprinters.org/prints/13208-dice-holder-and-dice-tray

go check that model out if you need a 5x1mm magnet version, or if you just want to support the original.