PAN-AM - 2-Sided Station Lightbox Sign

Bring back the golden era of full-service stations, porcelain signs, and real American garages.

This vintage-style round lightbox is inspired by classic illuminated service station signs and designed to mount perpendicular to the wall — just like the originals. Whether you're building a garage setup, bar corner, shop space, or man cave, this one makes a statement.

This model is fully 3D printable and designed for easy assembly and clean wiring.

• 50 mm total thickness
• Double-sided design (visible from both directions)
• Includes wall-mount brackets
• Hollow bracket arms for hidden LED wire routing
• Designed for LED strip lighting
• Clean, even light diffusion

• The included mounting brackets are hollow, allowing you to run your LED wiring directly through the arm for a clean, professional install — no exposed wires hanging down the wall.

• Super easy to install by using the hole jig found on plate 4.

• Just use the jig to mark your holes.

• Mount the brackets using drywall screws or similar with the wiring tunnel facing up for top bracket and down for bottom bracket. ( I found it easier to put my wire through before tightening the screws against the wall )

• Then slide the lightbox frame onto the mounts and push till it clicks into place.

• Next, just remove the adhesive backing strip and route your lights around the inside of the frame as many times as you would like.

• The design is intended to be used with your own LED light kit . The example shown was lit using a Cobb 5v wired strip like found here on amazon. https://a.co/d/0gaqt958

Printing Notes

• Printed in PLA for the example shown

• PETG or ABS will work as well if you prefer added durability.

Whether you’re lighting up your garage, bar, shop, or whiskey wall — this piece brings that old-school Americana glow.

FILAMENTS USED ON MY EXAMPLE:

• Bambu Basic PLA - Black

• Bambu Basic PLA - Cobalt Blue

•

Bambu Basic PLA - Jade White