Nocturne Game Insert and Organizer

**I should not have to add this to my posting.... DO NOT SELL MY WORK. My work is available for NON-COMMERCIAL USE ONLY. I make and upload inserts for free to give back to a community that has given so much to me. If you steal my stuff, I will make sure your site is taken down and you are banned.**

Flatout Games is one of my favorite publishers, so the haste at which I immediately unboxed Nocturne was uncanny...and then I realized how messy it was going to be in the box and how annoying it would be to setup.

To the 3D Printer!

I whipped up a quick insert for the Nocturne box after yanking the ridiculous cardboard one out. A few notes: Each player box has a slot for a 3- and 4- coin, because some setups require you to remove these, so it's just a handy place to keep these aside while you play. This insert does pass the shake test, but if you're unbothered by shaking boxes, you can skip printing the spacers.

Finally, if you remove the top and bottom layers on your spacers, you'll save both time and filament.

Enjoy!

Update, by request for our Ender friends, I've cut the NocturneBottomHalfSpacer.stl exactly in half to account for their very close margin of room on their beds. You can now choose to print ONE NocturneBottomHalfSpacer or TWO NocturneBottomQuarterSpacers. Enjoy!