Cribbage board - Compact 3-player

Folding Cribbage board for 3 players. This will fit a deck of cards in the middle.

The tracks are at different heights so you can color the tracks with a simple material change between layers. Cura's Post processing menu “Pause at Layer Height”

0.2mm layer height. 0.4mm nozzle. 2-3 walls, 4-6 top/bottom layers as-desired.

Pins print best in-sequence to prevent stringing. You'll need 6 minimum. A brim will be required.

Use a bit of super glue (I prefer clear gorilla) in the Top side slot before attaching the bottom and leaving it to set.

Secure the 2 Hinge pins by pressing them into the base.

UPDATE 2024-06-01 - Added Cribbage Pin 1-1a which should be easier to print and a better fit to the board. They're a bit thicker, with a taper down to the tip instead of a simple cylinder design.