Targi Organizer Piece Tray

When I printed the original piece tray, I noticed something weird: the Robber piece fit just fine in the pawns well, but it was slightly too big for the dedicated well (even though it's the same size). The Targia pawn had the same issue, only worse. I suspect this has something to do with the fact that it's a smaller cavity (thus perhaps more impacted by the infill pushing on the walls), and also with the fillets used inside the cavity. So I recreated the tray in Fusion as closely as I could, but made a few small changes:

• Made the Robber and Targia wells 0.5mm wider

• Made the Targia well 2mm shallower (since the piece is smaller)

• Removed the fillets from the inside of the wells (not really needed on an inside surface anyway)

• Positioned the wells more evenly

• Gave the central well a rounded bottom (because it's sexy)