Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.
Log in to join the conversation.
Gloomhaven: Jaws of the Lion - Monster Name Plates
1 plate
1h 8m
0.4 mm
33 g PLA Free
View Print on MakerWorld
Please support ddns by Liking/Boosting their Print on MakerWorld.
Before you print
✓ Needs about 33 g
I quickly designed name plates to replace the cardboard punch outs to work with the well designed insert here https://makerworld.com/en/models/2003086-gloomhaven-jaws-of-the-lion-organizer-insert . Unfortunately, the North American version name plates are too small to close the monster boxes. The fit is snug but does seem to loosen up after a few opens. You may want to print just one before printing the whole set to test out depending on filaments/calibration. Enjoy!
