Stuffed Fables proxy models

Modeled figures for the board game Stuffed Fables, Stuffed Fables.

Made in blender, taking as a model the images from the internet, so they are not scanned. more than 100 hours of work to give life to the game, or to replace any missing piece.

everything has been printed with 0.4mm nozzle, 0.08 layers and PLA+ eSUN, the 0.2 nozzle is not available to buy in the store, so there is a lot of room for improvement in the printing of the figures.

You can use tree stands, print the pieces flat, or tilt them 45º and print at 0.16 layer, the results are also very good and some figures like piggle, theodore, stitch and those that have thin pieces can be easier to remove stands.

As all hobby, take it with patience, the supports, which are quite many can cost to be removed, do not blame the model, the same if in the printing, your printer scratches and takes the supports and makes a bad impression. They have been printed on an A1 and a Creality K1, you can always use your print profile.

increase the distance in Z for the supports, in this case, for layer 0.08 they have a distance of 0.16.

in the picture you can see piggle printed at 45º and with 0.16 layer to check different results.

If you think a figure needs some modification, let me know and I will do my best to modify it within my possibilities.

Greetings and good printing.