Insert Let's go to Japan Sightseer premium sleeves

Insert for the boardgame “Let's go to Japan” (Sightseer pledge level).

It is designed to store cards with 120 microns sleeves but should work with slightly thicker sleeves and will work even better with thinner sleeves.

It fits in the sightseer box with zero-raise box top (please, be aware that the original box top is slightly shorter than the original box base, so it looks like if it was raised 1-2mm even when you close it with no components inside the box. But that is just the cardboard box design, have nothing to do with any insert).

I'm keeping the player components in plastic bags. If two or three people ask for it, I could add 4 simple boxes to store those components, but I found no reason to spend any more filament here, since the game storage seem perfectly well suited after printing these 4 deck and tokens holders.

Model Pictures Note: There was one small wall missing when I printed my insert. Even when it was 100% usable without that wall it feel anti aesthetic, therefore, the missing wall issue was fixed (and print-tested) before uploading the model. The real-life-pictures still featuring the old model, but the uploaded model will look like the one in the slicer pictures :)

ABOUT MAGNET INSERTIONS:

The deck-and-token-holder got two 10x2 mm magnet holes in the long deck-side with no token-holders.
If you want to insert 10x2 mm magnets, just add a pause at layer 77 (for the uploaded printing profile), put the magnets in the two holes of every piece and continue printing. BE AWARE OF MAGNETS POLARITY (in my printing I used one polarity for every magnet in the red inserts and the oposite in the blue inserts).
Important Note: The pause should be at layer 77 for the uploaded printing profile with a 0,2 mm layers. In case you use a different profile or modify something in this, just find the last layer with the magnet holes open in the slicer and add a pause there.