Log in to join the conversation.
JJ's Dice Box + Dice Stand (print-in-place)
Please support fav by Liking/Boosting their Print on Printables.
A small and simple dice holder for a set of 7 standard size dice. Can also be used as a dice stand when playing.
Completely print-in-place. While the latch's tolerances are pretty tight, but it works well. The main hinge is kinda loose, it's as tight as my printer allowed pretty much. However there's not much play in the hinge, and (at least on my print) it's got an additional feature where, thanks to the bridges sagging, it snaps into its fully open position (feature, not a bug :p).
The outside design requires some good bed adhesion. I recommend setting the bridge angle to 30-45 degrees. Leaving it at 0 will make the bottom sag way too much.
My print was printed on an Ender 3 V2 with a 0.4mm nozzle, with Aurapol's PLA in Yellow L-EGO colour.