Splendor Box

The original box is HUGE compared to the contents - so let's make more room on your shelf!

There are two files provided:

• With Separators - contains built-in card separators

• No Separators - does not contain the built-in separators

The two files are identical save for the card separators.

Print one of each for a full build. Or print two of the same type - both work!

• 0.25mm layer height

• No supports or brim

• I used PLA

In addition to printing the provided model, you will need:

• 10x5x2mm (8) magnets

• CA glue (for gluing in the magnets)

• 1/8" metal rod (for the hinge)

I found that gluing in the magnets is easiest one half at a time. Once one side is dry, put the 4 magnets on their counterparts to ensure proper polarity, then glue them into the other side.