Log in to join the conversation.
Small Time Heroes Board Game Insert
Please support Fletch by Liking/Boosting their Print on MakerWorld.
Designed to streamline setup and teardown with minimal lid lift, this system keeps all components securely in place and prevents unwanted shifting during storage or transport. This likely will only work with sleeved cards. The Token trays are optional. There might be enough space if you swap to smaller baggies to stuff them where the trays go.
Hero Boxes (Print 2)
• Each hero has a dedicated card box
• Stores their Hero card, Knowledge cards, and matching divider
Enemy Boxes (Print 4)
• Each enemy set has its own box
• Holds enemy cards and corresponding divider
Common Cards Box (Print 1)
• Designed to be placed directly into play and display the Challenge/Reward, Potions, and Intention Cards.
• Large rear slot : Enemy health tracker cards and the common divider
• Two narrow middle slots : Item cards (6 per slot)
• Left large slot : Challenge/Reward cards
• Deep enough to shuffle in 6 Item cards for campaign play
• Cutout allows visibility of Challenge/Reward cards without removal
• Right vertical slot : Potion cards
• Horizontal slot : Intention cards
• Cutout provides visibility without removing the card
• Front well : Wooden Health and Energy tracking cubes
Token Trays- These are a very tight fit, but it works.
• Tray 1 (Print 1)
• Single pocket for Strength tokens
• I put this one in last - the tokens just barely peek over the top of the tray.
• Tray 2 (Print 1)
• Long well: 1/2 Block tokens
• Short well: 3/5 Block tokens
• Tokens need to be vertical and bookcased in to fit well
• Tray 3 (Print 1)
• Three wells for Protection, Weakened, and Exposed tokens
• The Weakened tokens need to kind of lean over so they don't extend above the tray top.
Top Layer Storage
• Large Hero and Boss cards, along with the Rulebook, rest on top
• Lid lift is minimal but present
Sleeving Note
• All cards are sleeved with 100-micron sleeves
• Thicker sleeves will likely not fit within the designed compartments
• Sleeving the large Hero and Boss cards would increase the lid lift
• The smaller cards may not fit well if you do not sleeve them- the cutouts are fairly large.
Insert for sleeved cards.
