Dice Tray for Dnd

So I found that I often loose my dices under books, sheet of papers etc, so I decided to make this simple tray to have at least a place for 1 set

I Decided to engrave wich dice goes where, to make it easier for new players (and also experienced ones)

The holes are 6mm deep, the engraving is 0.5mm deep

Have fun, and good rolling

P.s. if you have any suggestion I'm open to them

!NEW STACKABLE BRACKETS FOR THIS TRAY!

Here is a multiple set version!

I also made a version with customizable press-fit labels! Check it out!

And even a fully modular version! click here to check it out!

If you like these models, give a go to my collection, with my ttrpg models and other ones!

The filament I used is from FlashForge - Burnt Titanium, added the bambulab one that looks the most similar