Blood on the Clocktower Name Plates and Organiser

Note: from using this, we found that the weight of the token holders are too high and end up moving too much during the night phase of BotCT. So in its current form, it is not the most practical but I will be looking for better solution soon.

A set of name plates to help keep track of who is who in Blood of the Clocktower, with organisers for up to 10 name plates.

The role tokens will fit into the Base Holders, and the name plates should snap into position below. A little tweaking may be required depending on your tolerances on your printing setup. You will need to stick some felt on the back of these so they stick to the backboard of the Clocktower tome.

There's a blank STL of the name plates, as well as the .stp file to add your own names. When printing, make sure you use a different colour for the top layers!

The magnets are bit overkill and you can get away with a 2 corner pairs on the containers rather than all 4, but I had enough hanging around.

Additional items needed:

•

Sticky-back felt cut into a 3x6cm (ish) rectangle per base holder

•

4x1mm magnets x16 (fairly obvious magnet holes on the organiser components)

•

Superglue

Don't let the demons win!