Dice Tray Magnets and Dice Tower Remix

I'm a big fan of the original design and made some changes to suit my preferences.

Dice Tower:

• Reduced the height by 1mm to better fit the dice tray when fully closed.

• Sloped the entire bottom as sometimes the dice wouldn't roll out and just stop on the flat bottom part inside the tower.

Dice Tray:

• Removed the original clasp system as I found that it would easily snap off.

• Added 6 slots for circular magnets (6x3mm). I find it better at holding the tray closed.
• FYI : Magnets were super glued into the slots to prevent them from falling out.

Printer Settings for models in pictures:

• Printer: Ender 3 Pro

• Layer Height: 0.2mm

• Infill: 20%

• Nozzle: 0.4mm

• Nozzle temp: 190°C

• Bed Temp: 60°C