Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.

Earthborne Rangers Insert

6 plates 8h 39m 0.4 mm 491 g PETG Free
View Print on MakerWorld

Please support Igor by Liking/Boosting their Print on MakerWorld.

Before you print
Needs about 491 g

An insert I've quickly made for myself to store the Earthborne Rangers cards, I'm uploading it here just in case someone will find it helpful

Note: I find the current height to be a bit too high, but only from the point of how convenient it is to get any given deck from the box, when all cards are inside.

Because of that, I tend to get at least the Paths insert from the box - it makes it much easier :)

Initially, I've made the height too low, so during transport cards were prone to fall out - so I might have overcompensated a little

P.S. I might not have time to fix problems with it in the near future, so feel free to adapt it yourselves, the .step file is attached

earthborne rangers board game insert