Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.
Log in to join the conversation.
Crokinole 20 Point Disk Holder for boards with 5 mm Edging
Free
View Print on Printables
Please support Mark Wheeler by Liking/Boosting their Print on Printables.
Crokinole 20 point disk holder fits snuggly on 5mm edge and holds 7 disks, or use optional stand to sit on table. My design has a floor so no gap for disks to fall through. Images shown using clear PETG filament
Easily print with PLA or PETG
Print holder vertically with supports
layer height 0.2mm is fine
If you have questions or suggestions for improvement please leave a comment.
/pic6874498.jpg)
/pic6893980.jpg)
/pic8009621.jpg)
