Spare support leg for Rummikub tile board

I made and printed this model for an acquaintance because their original set of was missing one leg and over years of usage, the crossed slots in the boards have been worn out a little causing the legs to fall out at the slightest nudge.

Printing tips (PLA as that is the only material I tried):

• I printed these upright (with the diagonal part at the top) with a brim.
• When printing 1: it might be good to let the part cool down in between layers when printing the slanted part as the part is relatively small and I got some less nice finish.
• When printing multiple: Make sure the brims aren't connected. Some legs might start to wobble and when the brims are conneted, they migth rip other stabe legs of (RIP my first batch)

I hope this model helps someone else