Portable Cribbage Board (8x2mm Magnets)

Welcome to this remixed Portable Cribbage Board!

This cribbage board holds a deck of cards and the pegs when it folds together.

From the original model, I adjusted the holes for the magnets to fit 8x2mm magnets. I also added 6 extra slots in the corner of the board for the pegs' starting point.

The magnets are used to help hold the board together when closed. There is a pause 13 minutes from the end for you to insert the four 8x2mm magnets. You should not have to glue the magnets in, because the hole is just big enough to fit the magnets snugly. Make sure to place the magnets so that the opposing poles will face each other when it folds.

Make sure to use a clean build plate. Cool Plate Supertack is recommended, but otherwise you may need to use glue for other build plates.

For 3D printed pegs, check out this model: https://makerworld.com/en/models/580424-crib-cribbage-pegs#profileId-501314