Emberleaf 3D Printable Insert

3D Printable Emberleaf insert can hold the following

1: Emberleaf Retail
2: Additional Hero Packs 1/2/3
3: Trophies + Bonuses Expansion
4: Bag'o'Upgrades (Wooden components)

Insert can be stored Vertical/Horizontal, no pieces are loose when stored with all components in the box.

Holds sleeved cards (tested up to 110 micron for all but solo cards which I expect will only support up to 60 micron)

Does not hold Bag'o'Banners (Wooden War Banners) or Bag'o'Colours (Alternative player colours) or Neoprene mats.
This insert also replaces the bags used to randomize the tiles for setup. (alternate process as listed below (5))

Advantages to this insert.

1: Top down optimized storage, Main Board + Player boards stored at the top as they are the first things required to setup the game, followed by each section of the setup having its own compartment to greatly increase setup speed.

2: Accommodates premium sleeves (up to 110 micron) (Solo deck only supports up to 60 micron) - with no Lid Lift.

3: All card types are separated, including individual starter decks.

4: Individual player containers, these can be handed out to each player at the start and contains everything the player needs (even reference cards!) aside from their player board + a random starter deck. (containers also have letters to indicate which animals go where)

5: Tile Randomizer (replaces bags) this setup allows for tiles to be taken from the bottom of the stack as they're stored, so the tiles are still randomized, but dont take up so much space with the bags - also makes things a lot tidier and easier to setup - while not 100% random as the tiles are stacked, this setup ensures you see the maximum variety of tiles without repeats between plays.

Video shows this - its easier with 2 hands by pressing on the top as you pull from the bottom, but can be done with 1 as shown :)

6: Blue cards are stored in separate containers that can be placed with the board, cards can be dealt directly from the insert piece, and the cards are angled slightly backward to avoid slippery sleeves causing cards to fall out when knocked.

7: 3MF file for Orca Slicer/Bambu studio with all files organised (supports placed on the randomizer to ensure no blockage on the bridged section)
Total filament = roughly 700g
Print time = roughly 17hrs over 3 plates (P1S))