Cribbage board design

Cribbage board designed in Fusion 360. It's a Work in Progress (WIP) and I have not printed it yet… I still need to add a pack of cards holder/drawer and a drawer insert for the pins. The full version as included is 400mm long with 2.5 mm pin holes but I figured it could be scaled down.

At 90% uniform scaling, the length drops to about 360mm and the card deck compartment should still accommodate a regular card deck (63mm x 88mm x 15mm). At 85% uniform scaling, the length is about 340mm and it should still fit a bridge card deck (57mm x 88mm x 15mm). It's also possible to use non uniform scaling to reduce the length a bit more and still fit a card deck… (Obviously when scaling down, the pin holes get smaller too so some experimenting will be required to select the right size pins to use…)

After slicing in CURA, I think the best way to print it would be vertically, with limited support (see photo).