All Time Wrestling Board Game Insert

This is a fully custom insert for the board game All Time Wrestling.

More specifically this currently contains contents from:

1. All Time Wrestling: All or Nothing 2nd Edition
2. ATW: Extreme Edition
3. ATW: A New Dawn
4. Matt Cardona expansion deck
5. Andre the Giant solo campaign

Even more specifically, it contains enough sets of health boards, dice, and cubes to allow four players to play two head to head matches.

I also created two extra deck boxes within that you can use to either: 1) Set up two player decks in them to hand out to each player going head-to-head. or 2) Use for the solo campaign, keeping the active wrestler in one box, and the used/unlocked campaign cards in the other.

Some things I'm happy with:
1. I believe I set up enough additional room to accommodate the upcoming Abu Dhabi Rumble expansion, and additional expansion decks if/when released (Such as the Eddie Guerrero deck currently on pre-order). The only drawback will be the need to remove the 3d Printed Dividers and replace them with Cardstock/Paper dividers, in order to create enough extra space for 12-13 more decks.
2. The deck boxes are nice, especially with the lid system I was able to set up. The lids provide a really satisfying click, and look really nice with the logo/belt I set up on them (Thanks to Cation Arts for providing the official font!).
3. Almost all the individual trays are perfectly sized, with enough room to grab out what you need, and enough room on the sides to pull out trays for easy setup and teardown.

Things I'm not happy with:
1. The larger card trays are at a significant angle (49.5 degrees) which isn't the easiest to put in and take out, especially at the edges of the tray. This was the only way I could get everything else to fit though, especially with all the large triple layer boards that had to go at the top of the box. It works, but it's not the best.
2. The larger card trays are too big for the plate on my printer. I split them up, then created tabs (thanks Shawn!) on one side, and slots in the other, and then used super glue to bind them (specifically a two step glue + activator spray). If it wasn't for the angle of the trays, I would have just made two separate pieces, but because of the space that would lose for cards, I went with this gluing situation.

**Update as of 05/2025**

I received my copy of Abu Dhabi Rumble and it was far more content that I realized. I have now given up on a single box solution for all content. I've now created a separate "Card Storage" Box using the Abu Dhabu box. If you printed the previous insert, you'll need to print two Rumble Card Long Trays and one Rumble Small Card Long Tray, as well as many of the Rumble Card Dividers as you'd like to separate things by category. I personally decided to use this box for all the individual decks. Additionally you'll want to toss the small card trays from the original box, and print out the Rumble Large Card Tilt Tray for that spot instead, to store the much larger Rumble Profile Cards.

As of this moment, this should store ALL content, minus any unnecessary repeat components ( I have enough cubes and player boards for two simultaneous 2v2 matches, but didnt keep anything beyond that).