TPU RPG dice tray

Are you annoyed by the clickey clackey sound of dice clattering on your new table? Or are your neighbours fed up with your dice hitting the floor?

I have something just for you!

This is a TPU made dice tray that allow you to roll your dices without worring about how loud it is! Specialy usefull with your new , shining, metal dice set ;)

Enough introduction...
This is model design for printing from TPU.
All you need (apart from a 3D printer and filament, of course) is 12 Fi6x2mm neodymium magnets.

1. Cut the file according to the settings below

- infil : 10%
- top layers : 5
- bottom layers: 3
- support : off

2. Print the model

3. Glue the magnets

Use a little cyanoacrylate adhesive (superglue). Pay attention to the polarity of the magnets !!!
The magnets on each corner of the print should be inserted so that they attract each other when folded

4. Fold and roll the dice!!!

I have prepared a model with three different dice roll results. I am also attaching a blank file.