Log in to join the conversation.
Rome and Roll Insert
Please support Patella by Liking/Boosting their Print on Thingiverse.
Fits all the current pieces for the Kickstarter edition of Rome & Roll. It should fit sleeved cards (definitely enough room up and down, and should be enough on all sides) -- but mine are not sleeved so I cannot say for certain. I tried to give you enough space to allow for padding the minis if you paint them. There should also be enough room for "standard" fine point dry erase markers.
Another "I don't know how useful this really is" insert -- but I keep learning, so I'm going to keep making them.
Print one copy of each file.
Simple insert. Tried to give enough room to pad the minis if you paint them. There should also be enough room for "standard" fine point dry erase markers if/when you replace the ones that came with the game. I cannot confirm with certainty, but I also believe I left enough room for sleeved cards. EDIT 10/14/20 OOPS. Sorry. It had been a couple of weeks since I'd printed the thing out and forgot a fairly important note. I manually set my bed size in Cura to 235x235 -- not the 210x210 or whatever Cura shows for Ender 3s by default these days. At this bed size, the card holder fits -- just by the skin of it's teeth. I used a taped down mirror on my bed, and even though I only had about an 1/8 of an inch of tape on the bed, I was printing onto that tape. You can't use any brims or skirts. And as I recall, I still had to rotate it on the bed. Even then, I technically still had size issues. The print ran into/rubbed against a couple of screws holding my upgraded power supply to the 3D printed base. So you may need to double check that you have y axis clearance as the print starts to grow into z axis space.
/pic7006634.jpg)
/pic7006613.jpg)
/pic5638555.jpg)
